Stiffen RH wingtip
The LH wingtip issue was rectified, with additional fibreglass layers being added to stiffen the front underside generally. After doing this, the question of whether I should do the same to the RH tip. Given the relative ease and low-damage risk of removing the wingtips and the fact I had a bit more epoxy and fibreglass cloth I decided to proceed. The fibreglass layers were added to the same area as with the LH wingtip.
Region that would flex greatly.
Two additional layers added to this region. Any ripples found were also cut out. Mounting strips were cleaned up and reattached.
Wingtip priming was cleaned up, a hole was rebuilt with flock.
Primer was cleaned up
Wingtip was reattached and alignment reconfirmed
Author
This post is from Adam Dickson
