Canopy hinge bracket and elevator idler arm
First two bonding tasks for the fuselage, and setting up the level

Leveling the fuselage and marking centre lines

Marking up idler bracket on rear bulkhead and prepping for bonding

Bonded and held in place with some self tappers

Idler ar temp fitted and elevator cable holes drilled

Slots cut in top of fuse for canopy hinge bracket. No action shots but some nerve wracking moments with the dremel to get it right

Hinge bracket bonded to the top of the rear bulkhead and held in place by screws during curing

Hinge protuding thru slots
This post is from Darren and Lee's Whisper X350 Gen II