Gary's Sling TSi

27 May 2023

Priming wing skin and completing left aileron and elevator control arm installation

Installed AN3-5A bolt into the elevator control arm and torqued to 6.5nm + 1.1nm drag = 7.6nm then applied torque seal

Primered left wing lower root skin, 2x aileron pushrod spacers, 2x fuel tank hatch covers and 2x trim tab control horns after degreasing them

Assembled the rest of the left aileron per the KAI. Applied Loctite 243, torqued the pushrod eyebolt bolt to 7.6nm and applied torque seal. Installed the balance tube. Riveted the remaining lower skin rivets and the upper skin rivets in place.

Previous post:
26 May 2023

This post is from Gary's Sling TSi

Next post:
28 May 2023 28 May 2023