16 & 17 Nov 2024

Some minor primer touchups completed

Fitted the aileron and elevator autopilot servos. These were quite tricky to fit given the tight confines within which to work. I reversed the direction of the bolts on the servo arms through the eyebolts to make them easier to fit.

Drilled and cleco'd the cowling top vent / louvre in place. Waiting for rivets to final install. I was considering using countersunk rivets, but the fiberglass is a bit thin to warrant the change

Installed dzu fastener sections for the rear seats underneath the luggage compartment floor

Enlarged holes in the front wheel spat for the towbar bushes and then fitted the bushes in position