Correction of wingtips part 4 - top surface
I created a fibreglass sheet from 4 layers. This was used as the "backbone" used to define corrected upper surfaces of the wingtip tails, reaching back the correct distance to match the tip skins 8.
Right wingtip ground back
Right wingtip new upper tip surface
4 woven layers
Right new top wingtip layer glued with slightly flocked epoxy and rivetted temporarily
Left wingtip
Left new top wingtip layer glued with slightly flocked epoxy and rivetted temporarily
Author
Previous post:
Correction of wingtips part 3 - Restoration and thickening of wingtip fibreglass edges
Correction of wingtips part 3 - Restoration and thickening of wingtip fibreglass edges
This post is from Adam Dickson
