HDP20 pin assignment
Connect A (forward)
Taxi lights
- 3 size 16 pins, pos, neg, shld
IBBS battery (shared with B connector)
- 1 size 16 pin (13A rating) - main aircraft bus (3 20AWG wires from DB15 wires condensed into 1 pin)
- 1 size 16 pin (13A rating) - gnd (3 20AWG wires from DB15 wires condensed into 1 pin)
- 4 size 20 pins, charge/sense, low voltage warning LED, batt info volt meter, backup power master
Tail ADS B-In
- 2 size 20 pins, serial rx, serial tx
Transponder
- 2 size 20 pins, serial rx, serial tx
Tail ADS B-in/ Transponder
- 2 size 20 pins, pwr, gnd
Stick
- 5 size 20 pins, lh trim up, lh trim down, rh tirm up, rh trim down, stick gnd (omit AP disconnect)
Servos
- 6 size 20 pins, net 1a, net 1b, net 2a, net 2b, pos, neg
Overhead lights
- 3 size 20 pins, white gnd, red gnd, pos
Trim
- 2 size 20 pins, red, green
Left wing OAT
- 3 size 20 pins, signal, pwr, gnd
Magnetos
- 3 size 20 pins, left, right, common shield
Start contactor
- 1 size 20 pin
Master contactor
- 1 size 20 pin
Wing OAT
- 2 size 20 pins
A subtotal
34 size 20, 5 size 16
Connect B (aft)
IBBS battery
- 1 size 16 pin (13A rating) - backup power output (4 20AWG wires from DB15 condensed into 1 pin)
Landing lights
- 4 size 16 pins, lh pos, rh pos, neg, shld
Nav/strobe lights
- 4 size 20 pins, nav pos, strb pos, neg, shld
GPS2020
- 4 size 20 pins, plus8v, gnd, serial rx, serial tx
USB
- 3 size 20 pins, pos, neg, shld
Flarm fusion
- 4 size 20 pins, serial rx, serial tx, pwr, gnd
COM radio
- 5 size 20 pins, gnd, pwr, enable, data rx, data tx
ELT beacon
- 5 size 20 pins, gnd, shld, elt rx, rmt sw, ext on
Flap control
- 5 size 20 pins, pos, gnd, flap up, flap down, airspeed
Intercom
- 6 size 20 pins, audio left, audio right, audio gnd, dim, pwr, gnd
B subtotal
35 size 20, 5 size 16
64 size 20 pins in all, 84 available
Several size 20 pin locations used to create keying (5 pins on each connector, losing 10 connections in all)
9 size 16 pins, 10 available
Size 16 pins no longer used for keying
This post is from Adam Dickson