Forward Seat Bulkhead Installation
Installation of the Forward Seat Bulkhead inside the Fuselage. Plans call for 2 inch fiberglass tape to be applied on left, right, and bottom forward and aft.

Center section glassed in. Excess epoxy was removed with paper towel method.

Micro dried and sanded smooth in preparation for glassing.

Micro filet drying.

After side of Lower seat back after drying and ready for sanding.

Micro has dried and is now ready for sanding.

Micro applied and sand bags used to keep the lower seat back propped up while the micro cures.

Fiberglass has been applied and is now left to cure.

Fiberglass applied and curing.

A close up of the forward port side corner as the glass is curing.

Close up of the forward starboard corner as the glass cures.
This post is from Clyde Oyler's Pulsar I