Wing component prep
Had several parts come out of primer and the primer failed to stick, significant peeling. My best guess is I didn’t clean the simple green degreaser completely, the parts were bone dry when primed, though colder temps is a possible issue as well. Need to do primer during the day, NOT using that stuff inside the garage. :-)
Wing accessories deburred and getting ready for primer
Freshly pressed bearing
Before primer
Pressing the bearing, a 13/16 impact socket was the perfect size for the job.
After, was trying to avoid overspray so taping off the top was fast, in hindsight this looks notsogreat, fortunately this is not a highly visible component and the untreated surface is non-contact so all good.
Safety wire attached, blue loctite was also used.
This post is from John's Rans S-21 Outbound